Bathroom remodel contractor Vancouver WA — NORBILT
Licensed Contractor · Clark County

Bathroom Remodeling
in Vancouver, WA

Tub-to-shower conversions, full gut remodels, vanity installs, tile work, and cosmetic refreshes — NORBILT handles every level of bathroom remodeling in Clark County. Licensed WA contractor. 1-year workmanship warranty.

Ready to start? (360) 216-9920

By Andrey· WA Licensed General Contractor · NORBILT · Updated August 2026
Licensed WA Contractor · #NORBI741CS
1-Year Workmanship Warranty
Free Written Estimates
2026 Cost Ranges

How Much Does a Bathroom Remodel Cost in Vancouver WA?

Prices below reflect installed cost — labor and materials — for Clark County projects in 2026. Your actual quote depends on tile selection, vanity spec, and whether the layout changes. We provide written estimates before any work starts.

Project Scope2026 Range
Cosmetic Refresh$800–$2,500
Mid-Range Update$5,000–$12,000
Full Gut Remodel$12,000–$25,000
Primary Bath Full Remodel$20,000–$45,000
Tub-to-Shower (Prefab Insert)$3,500–$7,000
Tub-to-Shower (Custom Tile)$6,000–$14,000

Ranges cover labor and standard materials in Clark County, WA. Premium tile, specialty fixtures, and structural changes add cost. Permits ($150–$600 depending on scope) are additional when required.

What's Included in a NORBILT Bathroom Remodel

Scope varies by project, but here's what a full gut bathroom remodel typically covers — and what falls outside our remodeling scope.

Included in a Full Gut Remodel

  • Demo — strip to studs, haul debris
  • Waterproofing membrane behind tile areas
  • Cement board substrate on walls and floor
  • Floor tile — set, grouted, and sealed
  • Wall tile or tub surround — set and grouted
  • Vanity and mirror installation
  • Toilet removal and new toilet set
  • All plumbing fixtures (faucet, showerhead, valve)
  • Exhaust fan replacement
  • Paint — walls and ceiling
  • Final caulk and cleanup

Not Included in Our Remodeling Scope

  • Moving the main supply or drain stack (separate plumbing scope)
  • HVAC work — heating, radiant floor heat (subcontracted if needed)
  • Window replacement
  • Door replacement (we install, but door is owner-supplied)
  • Appliances — towel warmers, heated mirrors

Moving plumbing? If your remodel involves relocating a drain or toilet, we coordinate licensed plumbing subcontractors and pull the required permit. This adds cost and time but is handled end-to-end.

Understanding Scope

Cosmetic Refresh vs. Full Gut: What's Right for Your Bathroom?

The scope you choose has a bigger impact on cost and timeline than any other single decision. Here's how to think through it.

Cosmetic Refresh — $800–$2,500

A cosmetic refresh updates everything visible without touching the tile or plumbing. New faucet, new light fixture, new mirror, new hardware, fresh caulk around the tub. Most are done in a single day. No permit required. This is the right scope when the bones are solid — when tile is in good shape, the layout works, and you just want the space to look less dated.

Good fit: fixtures more than 10 years old, builder-grade hardware, dated light bar, peeling caulk. Not a fit: cracked tile, mold behind the surround, soft floor, or a tub you never use.

Mid-Range Update — $5,000–$12,000

This scope replaces major surfaces and fixtures while keeping the existing layout. New floor tile, new vanity and mirror, new toilet, updated light fixture and exhaust fan. The plumbing stays in place — we work around the existing drain and supply locations. One to two weeks of work. A permit is not required unless something moves.

Good fit: functional layout, dated finishes across every surface, aging vanity or toilet, floor tile that's cracked or discolored. Not a fit: water damage, soft subfloor, or a layout change.

Full Gut Remodel — $12,000–$25,000

Demo to the studs, then rebuild from scratch. This is the right move when there's damage behind the tile, the subfloor is soft or rotted, or you want a completely different look. It allows for proper waterproofing, a new layout if needed, and a result that will last 20+ years. Permit required in Clark County when plumbing fixtures are relocated.

Signs you need a full gut: Tile that moves or sounds hollow, soft spots in the floor when you step on it, visible mold on grout that keeps coming back, a shower pan that's cracked or discolored past what cleaning fixes, or a tub surround that's peeling. These indicate water has gotten past the surface — a cosmetic fix won't solve it.

Tub-to-Shower Conversion — $3,500–$14,000

One of the most requested projects from Clark County homeowners. The tub comes out and a walk-in shower goes in its place. The prefab insert option ($3,500–$7,000) uses an acrylic or fiberglass surround — fast, clean, and easier to maintain. The custom tile option ($6,000–$14,000) uses cement board and tile throughout — more durable, fully customizable, and holds value better.

If the drain location stays the same, no permit is required in most cases. If the drain moves, Clark County requires a permit.

Project Timelines

How Long Does a Bathroom Remodel Take?

Timelines depend on scope, permit requirements, and tile cure time. Here's what to plan for in Clark County.

ScopeTimeline
Cosmetic Refresh1–2 days
Tub-to-Shower (Prefab Insert)2–3 days
Tub-to-Shower (Custom Tile)4–6 days
Mid-Range Update1–2 weeks
Full Gut Remodel2–4 weeks
Primary Bath Full Remodel3–5 weeks

Timelines run from project kickoff, not from initial contact. Tile cure time is the most common day-by-day constraint — grouting can't happen until the tile mortar cures, and the shower can't be used until the grout seals.

Clark County Permits

When Do You Need a Permit for a Bathroom Remodel?

No Permit Required

  • Like-for-like fixture replacement (same location)
  • Vanity swap — same plumbing location
  • Toilet swap — same drain location
  • New tile over existing substrate (cosmetic)
  • Light fixture swap on existing circuit
  • Exhaust fan swap — same location, same circuit
  • Caulk, grout, hardware, paint

Permit Required

  • Moving a drain or relocating a toilet
  • Adding a new electrical circuit or outlet
  • Moving supply lines to a new location
  • Adding a GFCI circuit where none existed
  • Converting tub to shower with drain relocation
  • Any structural wall changes

NORBILT pulls all required Clark County permits before work begins. We know what triggers a permit inspection and schedule accordingly — no surprises.

Frequently Asked Questions

Bathroom remodeling in Vancouver WA and Clark County.

01

How much does a bathroom remodel cost in Vancouver WA?

+
In 2026, a cosmetic bathroom refresh in Vancouver WA runs $800–$2,500. A mid-range update (vanity, tile, fixtures, same layout) typically costs $5,000–$12,000. A full gut remodel — demo to studs, new tile, new plumbing fixtures, vanity, and exhaust — runs $12,000–$25,000. A large primary bath with double vanity can reach $20,000–$45,000. These ranges cover labor and materials; actual quotes depend on your tile selection, vanity spec, and whether permits are required.
02

Do I need a permit for a bathroom remodel in Clark County?

+
Cosmetic updates — new fixtures in the same location, caulk, hardware, paint, tile over existing substrate — do not require a permit in Clark County. Permits are required when you move a drain, relocate a toilet, add or move an electrical circuit, or make structural changes. If you're converting a tub to a custom shower with a new drain location, a permit is typically required. NORBILT pulls all required permits before work begins and knows what Clark County Building Dept requires.
03

How long does a bathroom remodel take?

+
A cosmetic refresh takes 1–2 days. A tub-to-shower conversion with a prefab insert takes 2–3 days. A custom tile shower conversion takes 4–6 days including cure time. A mid-range update (vanity, tile, fixtures) takes 1–2 weeks. A full gut remodel takes 2–4 weeks, with permitting being the most common schedule driver. We confirm the exact timeline during your free estimate.
04

Can you match my existing tile?

+
We color-match grout before starting any tile repair or regrout project. For tile, an exact match depends on whether the same tile is still manufactured and available. We bring samples to the initial walkthrough so you can confirm the match before we order. If an exact match isn't possible, we'll show you the closest available options and discuss a full section replacement if needed.
05

What is a tub-to-shower conversion?

+
A tub-to-shower conversion removes your existing bathtub and installs a walk-in shower in that footprint. The prefab option uses an acrylic or fiberglass surround — faster and lower cost ($3,500–$7,000). The custom tile option uses cement board, waterproofing membrane, and tile — more durable and fully customizable ($6,000–$14,000). Most Clark County homeowners choose this when the tub is unused and they want to maximize a smaller bathroom.
06

Is your bathroom work warrantied?

+
Yes. All NORBILT bathroom remodeling is backed by a 1-year workmanship warranty. If caulk fails, tile lifts, grout cracks, or any installed component has a workmanship issue, we return and fix it at no charge within the warranty period. Manufacturer warranties on fixtures (faucets, toilets, exhaust fans) are separate and transfer directly to you.

Your Bathroom,
Done Right

Free written estimate, honest pricing, and a 1-year warranty on every bathroom project in Clark County.

Call Now Get Instant Estimate